Acer SmartRAID V Uživatelský manuál stáhnout pdf (Strana 84)

4-28

SMOR

Creating a Firmware Disk Image

To create the firmware backup diskette:

1. Press Ctrl+D when the DPT I2O BIOS banner appears during

system startup to start SMOR.

2. Move the highlight to the controller that you want to backup.

3. Insert a blank, formatted diskette into the host diskette drive.

NOTE This operation overwrites the entire diskette. Any existing

data is erased.

4. Press Alt+A to select the Action drop-down menu.

5. Select Save Firmware. Press Tab to highlight Ye s when prompted.

Press Enter to begin the flash update.

The operation starts immediately. SMOR displays a progress bar and

numerical percentage of completion. When the operation is complete you

can exit SMOR and start the system normally.

Restoring Firmware from a Disk Image

To use the firmware backup:

1. Insert the diskette with the backup images into your diskette drive.

2. Power on or restart your system. The system will boot from the

diskette and start SMOR automatically.

3. Highlight the controller that you want to update.

4. Press Alt+A to open the Action menu and select Flash HBA.

5. Highlight the diskette drive and press Enter. SMOR will display a

list of valid files on the diskette.

6. Highlight the software image you want to use and press Tab to

highlight OK.

Press Enter to start the flash update operation. SMOR will read the

file and verify that it is a valid flash image.

7. Press Tab to highlight Yes and press Enter to begin the flash update.

8. Press Enter when you see the confirmation prompt

9. When the flash update is complete you must restart the system to

enable the new software.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 255 256

Žádné komentáře

Acer SmartRAID V Uživatelský manuál Strana 84