Acer SmartRAID V Uživatelský manuál stáhnout pdf (Strana 89)

5-5

Software Installation

Upgrading an Existing System

NOTE If you have already installed a SmartRAID V controller into

your system and want to change drivers, refer to the Adding to

an Existing System section instead of this procedure.

To upgrade an existing Windows NT 4.0 system to a SmartRAID V

controller, follow the steps below:

1. From the Control Panel, select the SCSI Adapters icon. Then select

the Drivers tab and click Add.

2. Insert the DPT Windows NT diskette, then click Have Disk.

3. Select DPT I2O SCSI Adapter Driver for NT 4.0 and greater.

4. After the driver is loaded, shut down the system. Replace the

existing controller with the DPT SmartRAID V controller.

5. Boot the system.

6. If you are removing the old DPT controller, you should also remove

the old driver.

Adding to an Existing System

To add a DPT SmartRAID V controller to an existing Windows NT 4.0

system, do the following:

1. From Control Panel, select the SCSI Adapters icon. Then select the

Drivers tab and click Add.

2. Insert the DPT I

O drivers diskette, then click Have Disk.

3. Select DPT I2O SCSI Adapter Driver for NT 4.0 and greater.

4. After the driver is loaded, shut down the system. Install the new

DPT SmartRAID V controller into the system, leaving the existing

controller installed.

5. Boot the system.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 255 256

Žádné komentáře

Acer SmartRAID V Uživatelský manuál Strana 89